Before You Start
Firstly, we highly recommend that you have the following items before starting this process.
1. High Quality Bore Guide.
• Our Preferred bore guides is the Bore Tech. - They can be found here. Bore Tech AR Bore Guides
2. High Quality Cleaning Rod.
• Our Preferred Cleaning Rod is the Bore Tech Proof-Positive Cleaning Rod. - They can be found here. Bore Tech Cleaning Rod
3. High Quality Cleaning Jag.
• Our Preferred Cleaning Jag is the Bore Tech Proof-Positive Bore Stix Cleaning Jag. - They can be found here. Bore Tech Proof Positive Bore Stix Jag
4. High Quality Cleaning Patches.
• Our Preferred Cleaning Patches are again, from Bore Tech. - They can be found here. Bore Tech Patches
5. High Quality Nylon Bore Brush.
• Our Preferred Nylon Bore Brush is the Bore Tech Proof-Positive Bore Brush. - They can be found here. Bore Tech Proof-Positive Nylon Bore Brush
6. High Quality Bore Cleaning Solvent.
• Our Bore Cleaning Solvent of choice is Bore Tech Eliminator. It can be found here. Bore Tech Eliminator Cleaning Solvent
Additionally, during the entire procedure, please ensure that the steps below are always being followed.
1. Ensure that your weapon is always in a safe condition.
2. Ensure you are following the proper safety procedures.
3. Use proper PPE (Person Protective Equipment).
Barrel Cleaning Procedure
Barrels should only be cleaning when you have noticed a degradation of accuracy.
The number one cause of premature barrel failure is over cleaning.
After properly cleaning a barrel it make take approximately 50 - 100 rounds to to properly foul the barrel and achieve peak accuracy.
1. Wet 3 patches with Bore Tech Eliminator cleaning solvent.
2. Push all 3 wet watches through the bore individually. Only push patches through the bore in the direct of chamber to muzzle end.
3. Make 10 total passes with a tight fitting nylon bore brush saturated with Bore Tech Eliminator cleaning solvent.
• One total pass consists of a pass from the chamber to muzzle then back.
4. Wet 3 patches with Bore Tech Eliminator cleaning solvent.
5. Push all 3 wet watches through the bore individually. Only push patches through the bore in the direct of chamber to muzzle end.
6. Let Bore Tech Eliminator cleaning solvent soak inside of the barrel bore for 5 minutes.
7. Push dry patches through the bore until they come out clean and dry. Only push patches through the bore in the direct of chamber to muzzle end.
8. Enjoy your properly cleaned barrel!
